Aim- Use the given material data to build a hyper elastic material cards using Ls-Dyna. Build Mooney Rivlin and Ogden material card by finding their constants using d3hsp file. Perform uniaxial tensile test on Dogbone specimen with 100% strain (i.e. strain = 1) and compare the stress strain data in above cases. Theory-…

In this project, I will be simulating an incompressible-laminar-viscous flow through a backward facing step. This will be solved using the software OpenFOAM running on Debian. The solver for this simulation was chosen to be icoFoam, I decided what solver to use from this guide on OpenFOAM's website This is from their guide,…

Dog house design for the Door Trim:Aim: Create the Dog House for the Door Trim considering the design rules and performthe draft analysis for class A and create the final close body component and performthe draft analysis.Objective:Create the Tooling axis Design the class-B and class-C surfaces and join them.Use the Close…

AIM: Surface meshing on a Pressure valve Objectives: To check for the geometrical errors. To perform Topology cleanup accordingly. To set three different target lengths as three different cases and mesh the model. To apply any one target length from the above at a time for the entire model as One case. To write a…

Question 1: Compute lateral stiffness of the one story frame with an intermediate realistic stiffness of the beam. The system has 3 DOFs as shown. Assume L = 2h and Elb = Elc   Question 2: For the following structures: Determine the number of degrees-of-freedom for dynamic analysis Establish the equation…

AIM : To find out the critical frequencies of a rotating shaft in Solidworks. OBJECTIVES : To create 3D model of a rotating shaft. To perform frequency analysis on the rotating shaft and find out the critical frequencies. INTRODUCTION : For a rotating shaft there is a speed at which, for any…