Curve fitting using python

AIM : To write codes in Python to perform curve fitting. OBJECTIVE : To wite codes to fit a linear and cubic polynomial for the Cp data. To plot the linear and cubic fit curves along with the raw data points. To measure the fitness characteristics for both the curves. THEORY : Curve fitting…

PYTHON

Sourabh Lakhera
updated on 15 Jul 2020

Read more Projects by Sourabh Lakhera (21)

Week 3 - 2D meshing for sheet metal

Objective:

2D meshing and pre-processing for Car hood Metal Sheet OBJECTIVE:- Starting with the given Component (in 3D) of Automobile Car Hood, Performing Geometry clean-up and after Generating the Mid-Surface of the Model, then proceeding with Meshing of the Components under the Quality Criteria to meet the requirement of…

07 Jul 2021 02:37 PM IST

ANSA

Modelling and simulation of flow through a flowbench Using SolidWorks

Objective:

AIM: To create a 3D model of a flow bench and run flow analysis. OBJECTIVES : To obtain a plot of valve lift versus mass flow rate. Find the effect of valve lift on the mass flow rate. To run a parametric study for various valve lift. INTRODUCTION : An airflow bench is a device used for testing…

17 Jul 2020 01:47 PM IST

Frequency Analysis of a rotating shaft Using SolidWorks

Objective:

AIM : To find out the critical frequencies of a rotating shaft in Solidworks. OBJECTIVES : To create 3D model of a rotating shaft. To perform frequency analysis on the rotating shaft and find out the critical frequencies. INTRODUCTION : For a rotating shaft there is a speed at which, for any…

17 Jul 2020 01:44 PM IST

Solving second order Differential Equations using Python

Objective:

AIM: To simulate the transient behavior of a simple pendulum and to create an animation of it's motion. OBJECTIVE : To write a program in Python that solves the second-order ODE corresponding to the motion of a simple pendulum and to plot its angular displacement and angular velocity wrt time. To…

17 Jul 2020 01:32 PM IST