Week 3 - Adiabatic Flame Temperature calculation

                                                   MULTIVARIATE NEWTON RAPHSON SOLVER FOR ODE'S     Objective Solve the problem using Implicit Euler Method/Backward Differencing, assume…

                                                                                           …

                                                     AUTO IGNITION USING CANTERA   Objective To detrmine auto ignition and ignition delay time for methane combustion reaction for various…

                                                           ODE STABILITY Objective Literature review of ODE stability   Theory Numerical solution schemes are often referred…

                                               Compact Notation Derivation for a Simple Mechanism   Objective: To derive the reaction rate ODEs of a simple reaction mechanism learnt in the chemical…

                                                  Combustion Efficiency calculation after Preheating   Objective A furnace is used to burn Methane and Air Mixture. A recuperator is connected…

                                                        Handling Mixtures in Cantera   Objective   1. Use the "moles" method/function of the A object and explain how…

                                         ADIABATIC FLAME TEMPERATURE CALCULATION(using Cantera and Python)   Objective; 1. Adiabatic flame temperature variation with Equivalence ratio (In constant volume-chamber).…

                                                        COMBUSTION  Aim Part 1: To Perform a combustion simulation on the combustor model and plot the variation of the mass…

                                 Energy Chain Analysis of EV and ICEV   The Economic and Environmental reality of EV is far different than it seems so.Considering the Economic point of view EV's are expensive but it's up to Customer,Plus…

                                                               PARAMETRIC STUDY ON GATE VALVE   Aim To obtain the mass flow rate at the output for each design…

                                                        CYCLONE SEPERATOR   Aim To perform an analysis on a given cyclone separator model by varying the particle diameter,particle velocity and calculate the separation efficiency.   Introduction   A cyclone separator is an economical device for removing particulate solids…

                                                       CHT ANALYSIS ON A GRAPHICS CARD   AIM To run and simulate conjugate heat transfer of a typical Graphics card by varying…

                                                  Reyleigh  Taylor Instability AimTo perform the Reyleigh Taylor instability Simulation for 2 different mesh sizes and compare the results.Thereby…

                                                          EXHAUST PORT SIMULATION Aim To analyse Conjugate Heat Tranfer through an Exhaust Manifold Inroduction The term conjugate…

                                                  challenge 3#AHMED BODY Aim The aim  is to investigate experimentally the aerodynamic behaviour of the Ahmed body under grid dependancy…

                                                    FLOW OVER CYLINDER # challenge 3   Aim To Simulate the flow with the steady and unsteady case and calculate the Strouhal Number…

                                                                                           …