Week-11 Challenge: Braking

Q.Develop the Simulink model based on the given requirements and also create SLDD file and link the same to the model. Perform the complete V and V workflow for the obtained model   Development of TFT Cluster Speedometer Software Component   Cluster Instrument receives the signals from other ECU via CAN bus interface.…

Wiper control system Develop Simulink/state flow model for wiper control system based on the given conditions. Description of Challenge: If the density of the rain is low, then wiper rotates with low speed & the output signal should be 100rpm If the density of the rain is medium, then wiper rotates with medium speed…

Aim #1 :   For a defined driving cycle, calculate the energy required for braking. Theory : For a defined driving cycle, calculate the energy required for braking. At first, the drive cycle is determined in a Table and a plot is made. Using the plot, the values from the braking regions of the vehicle are…

Aim : 1. A. Explain a MATLAB demo model named ‘Speed control of a DC motor using BJT H-bridge’. Comment on the armature current shoot-up from the scope results. Refer to the help section of ‘The Four-Quadrant Chopper DC Drive (DC7) block’. Compare it with the H-bridge model. BAsic discussion…

 Aim 1 : Which types of power converter circuits are employed in electric and hybrid electric vehicle?   Explanation :     1 : AC to DC Converter (Rectifier) -  The prime source of electrical power coming from the grid is single/three-phase alternating current. While AC current…

Aim 1 : What is the difference between mapped and dynamic model of engine, motor and generator? How can you change model type? Theory : Tabular difference between mapped , dynamic , model of motor , generator, engine...  Sr no. :                      …

Aim : 1.   For EV_defaults_in file, if cargo mass is 500 kg with all other default conditions, can the vehicle travel for 45 km with FTP drive cycle? Conclude your  observations. Theory :    ADVISOR, NREL’s ADvanced VehIcle SimulatOR, is a set of model, data,…

  P r o j e c t    : 2   A d a p t i v e     C r u i s e    C o n t r o l [ ACC ] ◎-◉-◎-◉-◎-◉-◎-◉-◎-◉-◎-◉-◎-◉-◎-◉-◎-◉-◎-◉-◎-◉-◎-◉-◎-◉-◎-◉-◎-◉-◎-◉-◎-◉-◎-◉-   General Overview: Adaptive Cruise Control Feature for passenger cars allows the host vehicle…

  Mini  Project -  Vehicle  Direction  Determination   General Overview: Identifying the direction of the vehicle is one of the important & diverse features in Autonomous driving & Advanced Driver Assistance Features. This particular sub-feature of identifying…

Objectives: Carry out a system-level simulation of an all terrain vehicle and prepare a technical report explaining the model properties & comments on the results.   ALL TERRAIN VEHICLE: An all-terrain vehicle (ATV) is defined as a motorized off-highway vehicle designed to travel on four low-pressure or non-pneumatic…

Implement control logic of a "washing machine" using Stateflow as per given sequence: If the power supply is available, the system gets activated If the Water supply is not available, stop the process & indicate through LED Soaking time should be 200s followed by Washing time of 100s. Then rinsing happens for next…

Objective:   Make a Simulink model of Doorbell using a solenoid block with the following details: In the above arrangement, when the switch is closed the electromagnet receives electrical power from the battery and pulls the metal arm to hit the bell producing sound. Create a situation where the switch is closed for…