Aim- Use the given material data to build a hyper elastic material cards using Ls-Dyna. Build Mooney Rivlin and Ogden material card by finding their constants using d3hsp file. Perform uniaxial tensile test on Dogbone specimen with 100% strain (i.e. strain = 1) and compare the stress strain data in above cases. Theory-…

Draft Analysis When a plastic component is made, we can observe that there is a draft angle given on each side from the base which is lesser than 90 degrees. This is because in the criteria of making a plastic material the mold should release the material when finished. if the mold surfaces are 90 degrees…

Dog house design for the Door Trim:Aim: Create the Dog House for the Door Trim considering the design rules and performthe draft analysis for class A and create the final close body component and performthe draft analysis.Objective:Create the Tooling axis Design the class-B and class-C surfaces and join them.Use the Close…

AIM: Surface meshing on a Pressure valve Objectives: To check for the geometrical errors. To perform Topology cleanup accordingly. To set three different target lengths as three different cases and mesh the model. To apply any one target length from the above at a time for the entire model as One case. To write a…

AIM: DESIGN OF RESIDENTIAL BUILDING. Stpep:1 From the file menu new archithech sheet is taken for the modeling of the building. The units are converted into feet by using  the option project units from the manage toolbar. Using the line tool layout is  drawn for the development of the modeling. All the design…

Project 1_Comparative study of different storey buildings for Seismic forces   AIM : Comparative study of different storey buildings for Seismic forces   INTRODUCTION : There are 10 project of different story building (A, B, C, D, E, F, G, H, J, K).   Factors influencing the dynamic characteristics…