Fender Design - Wheel Arch Challenge

  1.Deutsch DT06 – 08SA     The above shown image is an connector with 8 terminal connection.  DT-06 - It's an series nuber 08SA-  It denotes the number of terminal connections in the connector.   Steps to define the part to work in an Electrical Harness Assembly In Part Design Work…

                                                                                           …

                                                                                                      ROOF DESIGN   An automobile roof or car top is the portion of an automobile that sits above the passenger compartment, protecting the vehicle occupants from sun, wind, rain, and other external elements.  The roof is designed…

                                                                                            SECTION MODULUS CALCULATION AND OPTIMIZATION  Section Modulus It is defined as the ratio of the moment of inertia of a section about its centroidal axis and to distance of extreme layer from neutral axis. It give as about an idea…

                                                                                           …

                                                                                           …

                                                                                           …

                                                                                           …

                                                                                           …

                                                                                           …

                                                                                          MASTER SECTION DEVELEPOMENT WITH B PILLAR What is Master Section? Master Sections are the guides for design requirements which shapes the component after technical styling of Class A Surfaces. The design features are created on the…

                                                                                      DOOR APLIQUE DESIGN…

DESIGN OF SCREW BOSS AND DOG HOUSE IN COIN HOLDER PART In this report we are going to see the design of screw boss and a dog house in a coin holder part . In the last model we sawed about the rib design and now we are goin to add screw boss and dog house.   DESIGN OF SCREW HOUSE  Before entering in to the screw…

                                                                                           …

                                                                                DETAILED REPORT OF  SWITCH BEZEL CORE AND CAVITY DESIGN     In the previous models we have seen the model of the part using Class A with tooling axis direction.Here we are going to see about the detailed report of Switch Bezel Core and Cavity…

                                                                                                  DEAILED REPORT OF COIN HOLDER DESIGN In this model of Coin Holder Design the following sections are we are going to do both practical and theoritical. Tooling Axis Creation Draft Analysis Report Design of the Part   Tooling…

                                                                                           …

                                                                                           …

                                                                                           …

DRAFT ANALYSIS ON FAN COVER  CLASS A MODEL                                 * Before start doing the axis sysytem for the Class A surface we need to check the given Class A model is correct.  Whether the all the surface are…

1.RADAR MAST      2.YACHT ASSEMBLY   3.MODEL OF SUNSEEKER     INTRODUCTION   In this project we are to learn the entire Modeling of an Sunseeker on solid works and solid works visualize.   The different components of the motorcycle we deal with are: Propeller Radar The Hull-Body of Ship Garage Door Front seat, Middle seat,…

        MODELING OF AMERICAN CHOPPER ON SOLIDWORKS   INTRODUCTION   In this project we are to learn the entire modeling of an American chopper on solid works and solid works visualize. The different components of the motorcycle we deal with are: Chassis Engine with exhaust system…