Project 1_Comparative study of different storey buildings for Seismic forces   AIM : Comparative study of different storey buildings for Seismic forces   INTRODUCTION : There are 10 project of different story building (A, B, C, D, E, F, G, H, J, K).   Factors influencing the dynamic characteristics…

AIM: To model and analyse G+25 multistory building using ETABS 2020 and to check the model and parameters as per IS 1893(1)-2016. INTRODUCTION: Modelling and analysis of G+25 multistory building using ETABS 2020 is being explained with step-by-step procedures PROCEDURES:  Open ETABS 2020 software Open New Model Project…

Project-1 Comparative Study of Different Story Buildings for Seismic     Forces   Factors influencing the dynamic characteristics of a building :- Buildings oscillate during earthquake shaking. The oscillation causes inertia force to be induced in the building. The intensity and duration of oscillation,…

Aim : To analysis a G+7 building with th same floor plan through out the levels. The structural model must comply with provisions of IS 1893 and IS 13920. To Run a modal response spectrum analysis and check analysis results of the etabs model for inter-storey drift requirements, vertical & planar irregularities,…

Modelling of 25 storey building with the specified properties using ETABS     Model a 25 storey building on ETABS with structural properties as specified below. Ground floor or plinth floor level can be taken at a height of 1.5 metres from the base. Each of the successive 25 storeys has a storey height of 3 metres.…

AIM:         TO MODEL AND ANALYZE MULTIPLE BUILDINGS WITH DIFFERENT FLOOR LEVELS AND DESIGN PARAMETERS USING ETABS SOFTWARE AND COMPARE THE RESULTS TO UNDERSTAND THEIR OVERALL SEISMIC BEHAVIOUR. INTRODUCTION:              The structural configuration of the building…